Vacuum‐driven fluid manipulation by a piezoelectric diaphragm micropump for microfluidic droplet generation with a rapid system response time

Recently, we developed a convenient microfluidic droplet generation device based on vacuum‐driven fluid manipulation with a piezoelectric diaphragm micropump. In the present study built on our previous work, we investigate the influence of settings applied to the piezoelectric pump, such as peak‐to‐peak drive voltage (V_p‐p) and wave frequency, on droplet generation characteristics. Stepwise adjustments to the drive voltage in ±10‐V_p‐p increments over the range of 200?250 V_p‐p during droplet creation revealed that the droplet generation rate could be reproducibly controlled at a specific drive voltage. The droplet generation rate switched within <0.5 s after the input of a new voltage. Although the droplet generation rate depended on the drive voltage, this setting had almost no influence on droplet size. The frequency over the selected range (50?60 Hz) did not markedly influence the droplet generation rate or droplet size. We show that the current fluid manipulation system can be conveniently used for both droplet generation and for rapid droplet reading, which is required in many microfluidic‐based applications.     

A simple,rapid and sensitive method based on modified multiwalled carbon nanotube for preconcentration and determination of lead ions in aqueous media in natural pHs

In this study, multiwalled carbon nanotube (MWCNT) was modified by the pyridine group using a silane agent and characterized by infrared spectroscopy (IR), thermal analysis (TG/DTA), and elemental analysis (CHN) and scanning electron microscopy (SEM). The application of this sorbent was investigated in determination of lead ions in aqueous samples, using flame atomic absorption spectrometry (FAAS). Through this study, different parameters such as pH and sample flow rate on adsorption process and eluent concentration, volume and flow rate were optimized. The limit of detection (LOD), the relative standard deviation and the recovery of the method were 2 ng mL^?1, 1.3% and 99.7%, respectively. Two standard reference materials (NIST 1571 and NIST 1572) were used to verify accuracy of this method. Finally, the sorbent was successfully applied for extraction and determination of low levels of Pb(II) ions in aqueous samples.     

Synthesis and properties of novel N,C,N terdentate skeleton based on 1,3-di(pyridin-2-yl)benzene moiety-new tricks for old dogs

Utilization of intermolecular Friedel-Crafts and intramolecular condensation reaction,novel 1,3-di-(pyridine-2-yl)benzene(N,C,N terdentate) skeleton with electro-withdrawing group in 6' position of pyridyl and a cyclization between 6' position of pyridyl and 6 position of benzyl ring were firstly designed and synthesized.The structures of these novel N,C,N terdentate were confirmed by NMR,MS and X-ray single crystalanalyses.The photophysical properties of these compounds were briefly explored.     

Growth and characterization of two-dimensional crystals for communication and energy applications

This review article covers the growth and characterization of two-dimensional (2D) crystals of transition metal chalcogenides, h-BN, graphene, etc. The chemical vapor transport method for bulk single crystal growth is discussed in detail. Top-down methods like mechanical and liquid exfoliation and bottom-up methods like chemical vapor deposition and molecular beam epitaxy for mono/few-layer growth are described. The optimal characterization techniques such as optical, atomic force, scanning electron, and Raman spectroscopy for identification of mono/few-layer(s) of the 2D crystals are discussed. In addition, a survey was done for the application of 2D crystals for both creation and deterministic transfer of single-photon sources and photovoltaic systems. Finally, the application of plasmonic nanoantenna was proposed for enhanced solar-to-electrical energy conversion and faster/brighter quantum communication devices.     

开关型Pickering乳液体系

Pickering乳液以胶体尺寸的固体粒子代替传统表面活性剂作为稳定剂,具有超稳定,生物相容性好以及对环境友好等优点。开关型Pickering乳液可随pH值、CO₂/N₂浓度、温度、磁场强度及光强度等条件的变化而改变固体乳化剂的表面润湿性,实现在“乳化”与“破乳”之间的快速转换,在非均相催化、乳液聚合等诸多领域有广泛的应用前景。本文全面总结了近年来开关型Pickering乳液的研究进展及其在界面催化系统、液膜处理有机废水、药物的包封与释放等方面的应用。     

水流损失和热补偿共同作用对增强型地热系统(EGS)产能影响的研究

基于青海共和盆地-3705m地热田实测数据,结合流固耦合传热理论并运用Comsol软件,建立了离散型裂隙岩体流体传热模型。考虑水流损失和热补偿共同作用,模拟得到了开采过程中上、下岩层(盖层和垫层)为绝热不渗透、传热不渗透、渗透传热时,储层(上、下岩层和压裂层)温度场的变化特征,分析了产出流量、水流损失、产出温度、产热速率的变化规律。研究结果表明:采热过程中产出流量始终小于注入流量;产出流量增幅速率先增大后减小,最后趋于稳定,前3a产出流量增幅超过总增幅量的3/4;忽略水流损失,将高估产热速率,采热初期甚至达到考虑水流损失时产热速率的3倍以上;考虑水流损失,产热速率呈先快速上升再趋于稳定后逐渐下降的趋势,最优开采时间为3a^11a;研究上、下岩层对产出温度的影响,仅考虑传热,采热寿命延长5.43%,同时考虑渗流传热时,采热寿命延长2.71%;采热前9a,水流损失占主导作用,即流入上、下岩层水流损失对产热速率的影响高于热补偿效应,开采10a后,热补偿效应占主导作用;同时考虑水流损失和热补偿效应得到的产热速率变化规律与实际工程更为符合,建议选择低渗透能力的上、下岩层延长增强型地热系统(EGS)运行时间。     

Information percolation and cutoff for the random‐cluster model

We consider the random‐cluster model (RCM) on with parameters p∈(0,1) and q ≥ 1. This is a generalization of the standard bond percolation (with edges open independently with probability p) which is biased by a factor q raised to the number of connected components. We study the well‐known Fortuin‐Kasteleyn (FK)‐dynamics on this model where the update at an edge depends on the global geometry of the system unlike the Glauber heat‐bath dynamics for spin systems, and prove that for all small enough p (depending on the dimension) and any q>1, the FK‐dynamics exhibits the cutoff phenomenon at with a window size , where λ_∞ is the large n limit of the spectral gap of the process. Our proof extends the information percolation framework of Lubetzky and Sly to the RCM and also relies on the arguments of Blanca and Sinclair who proved a sharp mixing time bound for the planar version. A key aspect of our proof is the analysis of the effect of a sequence of dependent (across time) Bernoulli percolations extracted from the graphical construction of the dynamics, on how information propagates.     

基于CARS技术的超燃冲压发动机点火过程温度测量

相干anti-Stokes Raman散射（coherent anti-Stokes Raman scattering，CARS）技术作为一种非接触测量手段，已广泛应用于多种发动机模型燃烧室温度测量及地面试验.然而，目前的工作主要集中在稳态燃烧场温度的测量，缺乏用高分辨率的单脉冲来测量瞬变的燃烧火焰温度及组分浓度的研究.基于CARS理论，结合多参数拟合算法，开发了基于MATLAB的CARS光谱计算和拟合程序CARSCF；利用McKenna平面火焰炉在不同工况下进行了温度测量，并与DLR测量结果进行对比，结果显示开发的CARSCF具有较高的测量重复性和准确性；最后将CARS技术应用于测量超燃冲压发动机点火过程中的温度测量，获取了点火过程中的温度.结果显示，在来流Mach数为3的条件下，H₂/air点火过程中温度呈现急剧上升然后缓慢下降，而CARS信号则呈现急剧上升然后急剧下降随后又缓慢上升的趋势，并且在点火过程中最高温度为1 511 K.      

Scattering of Tollmien-Schlichting waves by localized roughness in transonic boundary layers

The laminar-turbulent transition in boundary-layer flows is often affected by wall imperfections, because the latter may interact with either the freestream perturbations or the oncoming boundary-layer instability modes, leading to a modification of the accumulation of the normal modes. The present paper particularly focuses on the latter mechanism in a transonic boundary layer, namely, the effect of a two-dimensional(2 D) roughness element on the oncoming Tollmien-Schlichting(T-S) modes when they propagate through the region of the rapid mean-flow distortion induced by the roughness. The wave scattering is analyzed by adapting the local scattering theory developed for subsonic boundary layers(WU, X. S. and DONG, M. A local scattering theory for the effects of isolated roughness on boundary-layer instability and transition: transmission coefficient as an eigenvalue. Journal of Fluid Mechanics, 794, 68–108(2006)) to the transonic regime, and a transmission coefficient is introduced to characterize the effect of the roughness. In the sub-transonic regime, in which the Mach number is close to, but less than, 1, the scattering system reduces to an eigenvalue problem with the transmission coefficient being the eigenvalue; while in the super-transonic regime, in which the Mach number is slightly greater than 1, the scattering system becomes a high-dimensional group of linear equations with the transmission coefficient being solved afterward. In the largeReynolds-number asymptotic theory, the K′arm′an-Guderley parameter is introduced to quantify the effect of the Mach number. A systematical parametric study is carried out,and the dependence of the transmission coefficient on the roughness shape, the frequency of the oncoming mode, and the K′arm′an-Guderley parameter is provided.